"We were able to contact some owners through warranty card information, but that only accounted for a quarter of all the Heatpipe furnaces out there. "We launched a nationwide publicity campaign last October," said Chuck Russ, York's director of market development. York made about 10,000 Heatpipe furnaces between 19 under the brand names Borg-Warner, Luxaire, Fraser-Johnson and Moncrief. The company, based in York, Pa., agreed to replace the furnaces and allow $200 for installation. If false flame has been sensed, the control will return to normal operation, and repeat ignition sequence when the false flame is not present.IN a graphic illustration of the frustrations of trying to recall defective consumer products, the manufacturer of a gas furnace linked to 10 carbon monoxide deaths in the Chicago area three years ago is having trouble finding owners of 4,000 furnaces still in use nationwide.Īs part of a settlement with the Consumer Product Safety Commission, the York International Corporation, maker of the Heatpipe Gas Furnace, agreed to send letters to owners warning that the vent system could fail, causing poisonous carbon monoxide to leak into the home. The control is in lockout because a failed ignition attempt, a gas valve error, or a false flame sensed during the warm up period. The control is in lockout because the signal was not received by the control that the inducer centrifugal switch had closed within the time. The control is in lock-out because the inducer centrifugal switch is or was stuck closed. #Moncrief furnace troubleshooting seriesIntertherm M5S Series Furnace Troubleshooting RED LED INDICATOR If no power to combustion blower then check wiring and control module replace if necessary.Check for 115 volts to the combustion blower motor replace if necessary.Gas valve stuck open, check gas valve for proper operation (replace if necessary) and inspect heat exchanger.The nominal setting is 0.4.Ĭirculation Air Blower Will Not Operate Even Thouoh The Burner Does Operate Be sure unit is not undersized for its thermal load.Check burner for proper gas firing rate.Check for clean filter and proper air flow. Thermostat should not be located where it will be affected by another heat source.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |